The standard settings of both front and rear suspensions are selected to meet various riding conditions such as low to high motorcycle speed and light to heavy load on the motorcycle.
The suspension settings can be adjusted for your preference and fine-tuning.
Specifications
Service data
Suspension
unit: mm (in)
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Rear suspension components” “rear suspension assembly
construction”
Reference: for the tightening torque of fastener ...
Immobilizer description (for e-02, 19, 24, 51)
The immobilizer, an anti-theft system, is installed as a
standard equipment.
The immobilizer verifies that the key id agrees with ecm
id by means of radio communication through the
immobilizer antenna. When the id agreement is verified,
the system makes the engine ready to start.
...
Ignition switch inspection
Inspect the ignition switch in the following procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the ignition switch lead wire coupler (1).
Inspect the ignition switch for continuity with a tester.
If ...