Removal
Note remove the swingarm pivot boss only when replacing it. |
Installation
Install the swingarm pivot boss in the reverse order of removal. Pay attention to the following points:
Tightening torque swingarm pivot boss nut (a): 65 n·m (6.5 Kgf-m, 47.0 Lbf-ft)
DTC “c11” (p0340): cmp sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
The signal does not reach ecm for 3 sec. Or more, after
receiving the starter signal.
Cmp sensor circuit open or short.
Cmp sensor malfunction.
Ecm malfunction.
...
Rear shock absorber inspection
Refer to “rear shock absorber removal and installation” .
Shock absorber
Inspect the rear shock absorber for damage and oil
leakage, and absorber bushing for wear and damage. If
any defect is found, replace the rear shock absorber with
a new one.
Caution
do not attempt to disassemble ...
Front wheel removal
Place the motorcycle on the
side stand.
Remove both brake calipers
from the front forks by removing
two mounting bolts 1 on
each calipers.
Note: never squeeze the front
brake lever with the caliper
removed. It is very difficult to force
the pads back into the caliper
asse ...