Removal
Installation
Install the thermostat in the reverse order of removal.
Pay attention to the following points:
Note air bleeder hole “a” of the thermostat faces upside. |
Tightening torque thermostat cover bolt (a): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft)
Regulator / rectifier removal and installation
Removal
Turn the ignition switch off.
Remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Remove the evap system purge ...
Windshield cleaning
Clean the windshield with soft
cloth and warm water with mild
detergent. If scratched, polish
with a commercially available
plastic polish. Replace the windshield
if it becomes scratched or
discolored so as to obstruct view.
When replacing the windshield,
use suzuki replacement windshield. ...
Front brake caliper parts inspection
Refer to “front brake caliper disassembly and assembly” .
Brake caliper cylinder
Inspect the brake caliper cylinder wall for nicks,
scratches or other damage. If any damage is found,
replace the caliper with a new one.
Brake caliper piston
Inspect the surface of brake caliper pistons for a ...