Removal
For e-33
models, drain fuel from the fuel tank before disconnecting the fuel feed hose to prevent fuel leakage. |
Caution after disconnecting the throttle cables, do not snap the throttle valve from full open to full close. It may cause damage to the throttle valve and throttle body. |
Installation
Installation is in the reverse order of removal. Pay attention to the following points:
|
Tightening torque throttle cable lock-nut: 4.5 N·m (0.45 Kgf-m, 3.0 Lbf-ft)
Refer to “isc valve reset” and “tp reset” .
Evap canister hose routing diagram (only
for e-33)
Evap system purge control solenoid valve
Surge hose
Purge hose
Fuel shut-off valve
Rear fender
Evap canister
Seat hook
White marking
Yellow marking
Up
Face the
clamp end downward
Face the
clamp end to the left
Pass the
...
DTC “c22” (p1450-h/l): ap sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C22
Ap sensor voltage is not within the
following range.
0.5 V ≤ Sensor voltage < 4.85 V
Note
note that atmospheric pressure
varies depending on weather
co ...
Starter clutch inspection
Refer to “starter clutch removal and installation” .
Starter clutch
Install the starter driven gear onto the starter clutch.
Turn the starter driven gear by hand to inspect the
starter clutch for a smooth movement. The gear
turns in one direction only. If a large resistance is felt
...