Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Throttle cable play inspection and adjustment

Inspect throttle cable play initially at 1 000 km (600 miles, 2 months) and every 6 000 km (4 000 miles, 12 months) thereafter

Inspect and adjust the throttle cable play “a” as follows:

Throttle cable play “a” 2.0 – 4.0 Mm (0.08 – 0.16 In)

Suzuki GSX-R. Throttle cable play inspection and adjustment


  1. Remove the boot (1).
  2.  Loosen the lock-nut (2) of the throttle pulling cable.
  3.  Turn the adjuster (3) in or out until the throttle cable play “a” (at the throttle grip) is within 2 – 4 mm (0.08 – 0.16 In).
  4.  Tighten the lock-nut (2) while holding the adjuster (3).
  5.  Fit the boot (1) positively onto the adjuster.

Suzuki GSX-R. Throttle cable play inspection and adjustment


After the
adjustment is completed, check that handlebar movement does not raise the engine idle speed and that the throttle grip returns smoothly and automatically.
Engine oil and filter replacement
Replace engine oil initially at 1 000 km (600 miles, 2 months) and every 6 000 km (4 000 miles, 12 months) thereafter Replace oil filter initially at 1 000 km (600 miles, 2 months) and every 18 0 ...

Pair system inspection
Inspect pair system every 12 000 km (7 500 miles, 24 months) Inspect the pair (air supply) system periodically. Refer to “pair system inspection” in section 1b . Throttle valve synchronization ...

Other materials:

Crankcase emission control system description
The engine is equipped with a pcv system to prevent discharging crankcase emissions into the atmosphere. Blow-by gas in the engine is constantly drawn into the crankcase, which is returned to the combustion chamber through the pcv (breather) hose, air cleaner and throttle body. ...

DTC “c11” (p0340): cmp sensor circuit malfunction
Detected condition and possible cause Detected condition Possible cause The signal does not reach ecm for 3 sec. Or more, after receiving the starter signal. Cmp sensor circuit open or short.  Cmp sensor malfunction.  Ecm malfunction. ...

Front brake pad inspection
The extent of brake pads wear can be checked by observing the grooved limit line “a” on the pads. When the wear exceeds the grooved limit line, replace the pads with new ones. Refer to “front brake pad replacement” . Caution replace the brake pad as a set, otherwise braking perform ...

© 2011-2024 Copyright www.suzukigsxr.org