Suzuki GSX-R 1000 Service Manual: Throttle cable routing diagram

Suzuki GSX-R 1000 Service Manual / Engine / Engine mechanical / Schematic and routing diagram / Throttle cable routing diagram

Suzuki GSX-R. Throttle cable routing diagram

Throttle cable no. 1
Throttle cable no. 2
Clutch cablev
Front brake hose
Pass
the throttle cables in front of the front brake hose.
Pass the
clutch cable above the right air intake pipe.
Clamp the
clutch cable at the white taping point and make sure it does not slip out of the clamped position when steering.

Cut off the excess tip of the clamp.
Pass the
clutch cable outside of the regulator/rectifier harness and water bypass hose.
4.5 Nm (0.45 Kgf-m, 3.0 Lbf-ft)
0 – 1 Mm (0 – 0.04 In)

Camshaft and sprocket assembly diagram

...

Diagnostic information and procedures

Engine mechanical symptom diagnosis Refer to “engine symptom diagnosis” in section 1a . Compression pressure check The compression pressure reading of a cylinder is a good indicator of its interna ...

Other materials:

Vehicle identification number
The frame serial number or V.I.N. (Vehicle identification number) “a” is stamped on the right side of the steering head tube. The engine serial number “b” is located on the lower crankcase. These numbers are required especially for registering the machine and ordering spare parts. ...

Throtile cable play
This motorcycle has a twin throttle cable system. Cable A is for pulling cable and cable B is for returning. To adjust the cable play: Loosen the lock nut 1. Turn the adjuster 2 so that the throttle grip has 2.0 - 4.0 Mm (0.08- 0.16 In) play.Tighten the lock nut 1. ...

Break-in
The first 800 km (500 miles) is the most important in the life of your motorcycle. Proper operation during this break-in period will help assure maximum life and performance from your new motorcycle. The following guidelines explain proper break-in procedures. Maximum engine speed recommen ...