Note the specified tightening torque is described in the following. “Throttle cable routing diagram” “throttle body components” “throttle body construction” “engine assembly installation” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Rear brake hose removal and installation
Removal
Drain brake fluid. Refer to “brake fluid replacement” .
Remove the rear brake hoses as shown in the rear brake hose routing
diagram. Refer to “rear brake hose routing diagram” .
Installation
Caution
the seal washers should be replaced with
new ones to prevent ...
Hazard switch inspection
Inspect the hazard switch in the following procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the left handlebar switch coupler (1).
(Yellow)
Inspect the hazard switch for continuity with the
tes ...
Front wheel assembly construction
Brake disc bolt
Brake caliper mounting bolt
Front axle bolt
Front axle pinch bolt
Clearance
18 N·m (1.8 Kgf-m,
13.0 Lbf-ft)
39 N·m
(3.9 Kgf-m, 28.0 Lbf-ft)
100 N·m
(10 kgf-m, 72.5 Lbf-ft)
23 N·m
(2.3 Kgf-m, 16.5 Lbf-ft)
...