Suzuki GSX-R 1000 Owners Manual: Tire pressure and loading
Proper tire pressure and proper tire loading are important factors.
Overloading your tires can lead to tire failure and loss of vehicle control.
Check tire pressure each day before you ride, and be sure the pressure is correct for the vehicle load according to the table below.
Tire pressure should only be checked and adjusted before riding, since riding will heat up the tires and lead to higher inflation pressure readings.
Under-inflated tires make smooth cornering difficult, and can result in rapid tire wear. Over-inflated tires have a smaller amount of tire in contact with the road, which can contribute to skidding and loss of control.
Note
: when you detect drops in tire pressure, check the tire for nails or other punctures, or a damaged wheel rim. Tubeless tires sometimes lose pressure gradually when punctured.
Tires
Warning
Failure to follow these warnings
may result in an accident
due to tire failure. The tires on
your motorcycle form the crucial
link between your motorcycle
and the road ...
Tire condition and type
Tire condition and tire type affect
motorcycle performance. Cuts or
cracks in the tires can lead to tire
failure and loss of motorcycle
control. Worn tires are susceptible
to puncture failures an ...
Other materials:
Air bleeding from brake fluid circuit
Air trapped in the brake fluid circuit acts like a cushion to
absorb a large proportion of the pressure developed by
the master cylinder and thus interferes with the full
braking performance of the brake caliper. The presence
of air is indicated by “sponginess” of the brake lever and
also by la ...
Specifications
Service data
Fi sensors
Tightening torque specifications
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...
Front turn signal light bulb replacement
Caution
when you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
Remove the turn signal light assembly.
Remove the socket (1) by turning it
counterclockwise.
Repla ...