Removal
Installation
Install the to sensor in the reverse order of removal.
Pay attention to the following point:
Stp sensor inspection
Refer to “dtc “c29” (p1654-h/l): secondary throttle position sensor (stps) circuit malfunction” in section 1a .
Speed sensor inspection
Inspect the speed sensor in the following procedures:
remove the speed sensor. Refer to “speed sensor removal and
installation” .
Connect a 12 v battery (between b and b/w), 10 kù
resistor (between b/r and b) and multi-circuit tester
(tester (+) probe to b and tester ...
Foreword
Motorcycling is one of the most
exhilarating sports and to ensure
your riding enjoyment, you should
become thoroughly familiar with
the information presented in this
owner's manual before riding the
motorcycle.
The proper care and maintenance
that your motorcycle requires is
outlined in t ...
Regulator / rectifier removal and installation
Removal
Turn the ignition switch off.
Remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Remove the evap system purge ...