Inspect the tp sensor setting position and adjust it if necessary in the following procedures:
Special tool
: 09930–82720 (mode selection switch)
|
Special tool : 09930–11950 (torx wrench (5 mm))
Tightening torque tp sensor mounting screw: 3.5 N·m (0.35 Kgfm, 2.5 Lbf-ft)
DTC “c14” (p0120-h/l): tp sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C14
Output voltage is not within the following
range.
Difference between actual throttle opening
and opening calculated by ecm is larger
than specified value.
0.2 V ≤ Sensor ...
Battery visual inspection
Inspect the battery in the following procedures:
remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of th ...
Front wheel components
Front axle
Brake disc bolt
Brake disc
Dust seal
Bearing
Spacer
Air valve
Front wheel
Wheel balancer
Front tire
Collar
Front axle bolt
18 N·m (1.8 Kgf-m,
13.0 Lbf-ft)
100 N·m
(10.0 Kgf-m, 72.5 Lbf-ft)
Apply ...