Refer to “throttle body disassembly and assembly” in section 1d .
Removal
Special tool : 09930–11950 (torx wrench (5 mm))
Note prior to disassembly, mark the tp sensor’s original position with a paint or scribe for accurate reinstallation. |
Installation
Install the tp sensor in the reverse order of removal.
Refer to “throttle body disassembly and assembly” in section 1d .
Turn signal / side-stand relay inspection
Refer to “electrical components location” in section 0a .
Note
make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signa ...
Accessory use
The addition of unsuitable accessories
can lead to unsafe operating
conditions. It is not possible
for suzuki to test each accessory
on the market or combinations of
all the available accessories; however,
your dealer can assist you in
selecting quality accessories and
installing them correc ...
Engine assembly installation
Install the engine in the reverse order of engine removal.
Pay attention to the following points:
before installing the engine, install the collars (1).
Before installing the engine, install the engine
mounting thrust adjusters (2).
Gradually raise the rear side of ...