Countershaft assembly
Gearshift fork and gearshift cam
Driveshaft assembly
Bearing and oil seal
Note if there is no abnormal condition, the oil seal and bearing removal is not necessary. |
Caution the removed oil seal and bearing must be replaced with a new one. |
Caution be careful not to lean the bearing remover. |
Special tool
(a): 09923–74511 (bearing remover)
(b): 09930–30104 (rotor remover
sliding
shaft)
Special tool
(c): 09921–20240 (bearing remover
set)
Special tool
(d): 09913–70210 (bearing
installing set (10
– 75 Ô))
Special tool
(d): 09913–70210 (bearing
installing set (10
– 75 Ô))
Fuel injector inspection and cleaning
Inspect the fuel injector in the following procedures:
remove the fuel injector. Refer to “throttle body disassembly and
assembly” in section 1d .
Check the fuel injector for evidence of dirt and
contamination. If present, clean and check for
presence of dirt in the fuel lin ...
Fuel level gauge inspection
Inspect the fuel level gauge in the following procedures:
remove the fuel pump. Refer to “fuel pump disassembly and assembly” in
section 1g .
Measure the resistance at each fuel level gauge in
float position. If the resistance is incorrect, replace
fuel level gauge with a ne ...
Precautions
Precautions for exhaust system
To avoid
the risk of being burned, do not touch the exhaust system when the
system is hot. Any
service on the exhaust system should be performed when the system is
cool.
Caution
make sure that the exhaust pipes and muffler ...