To replace the turn signal light bulb, follow these directions.
Caution Overtightening the screws may cause the lens to crack. Tighten the screws only until they are snug. |
Speed sensor inspection
Inspect the speed sensor in the following procedures:
remove the speed sensor. Refer to “speed sensor removal and
installation” .
Connect a 12 v battery (between b and b/w), 10 kù
resistor (between b/r and b) and multi-circuit tester
(tester (+) probe to b and tester ...
Drive mode selector description
Engine power characteristics can be changed in 3
modes by operating the drive mode selector to meet
various riding conditions and rider’s preference.
Operation
Drive mode is preset at a-mode when the ignition switch
and engine stop switch are turned on. Follow the
procedure below to operat ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Throttle body components” “engine bottom side assembly”
Special tool
...