Refer to “electrical components location” in section 0a .
Note make sure that the battery is fully charged. |
Before removing the turn signal/side-stand relay, check the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the bulb, turn signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are ok, the turn signal relay may be faulty; therefore, replace the turn signal/side-stand relay with a new one.
Refer to “turn signal / side-stand relay removal and installation” .
Exhaust system components
Exhaust pipe gasket
Exhaust pipe assembly
Ho2 sensor
Connector
: install the connector so that the
chamfer side faces backward.
Muffler chamber
Muffler body
Excv cable no. 1
Excv cable no. 2
When loosening or tightening the pulley bol ...
Diagnostic information and procedures
Engine lubrication symptom diagnosis
Oil pressure check
Check the engine oil pressure periodically. This will give
a good indication of the condition of the moving parts.
Note
before checking the oil pressure, check the
following.
Oil level (refer to “engine oil and fi ...
Front seat
To remove the front seat.
Remove the bolts 1 (right and
left).
Raise the front end of the seat
and slide it forward.
To reinstall the seat, slide the seat
hooks into the seat hook retainers
on the frame and tighten the bolts
securely.
Warning
Failure to insta ...