Suzuki GSX-R 1000 Service Manual: Turn signal / side-stand relay removal and installation
Removal
- Turn the ignition switch off.
- Remove the frame cover assembly. Refer to “exterior parts removal and installation” in section 9d .
- Remove the turn signal/side-stand relay (1).
Installation
Install the turn signal/side-stand relay in the reverse order of removal.
Starter relay inspection
Inspect the starter relay in the following procedures:
remove the starter relay. Refer to “starter relay removal and
installation” .
Apply 12 v to “a” and “b” terminals and check ...
Side-stand / ignition interlock system parts
inspection
Check the interlock system for proper operation. If the
interlock system does not operate properly, check each
component for damage or abnormalities. If any
abnormality is found, replace the compon ...
Other materials:
Drive chain cleaning and lubricating
Clean and lubricate drive chain
every 1 000 km (600 miles)
Clean and lubricate the drive chain in the following
procedures:
clean the drive chain with kerosine. If the drive chain
tends to rust quickly, the intervals must be
shortened.
Caution
do not use trichloroethyle ...
Engine bottom side disassembly
Note
the crankcase must be separated to service
the crankshaft and conrod.
Remove the engine assembly from the frame. Refer to “engine assembly
removal” .
Remove the engine top side (1). Refer to “engine top side disassembly”
.
Crankcase breather (pcv) cover
R ...
Front turn signal light removal and installation
Removal
Remove the screw.
Disconnect the front turn signal coupler (1).
Remove the turn signal light assembly (2).
Installation
Install the front turn signal light in the reverse order of
removal. ...