Suzuki GSX-R 1000 Service Manual: Turn signal switch inspection
Inspect the turn signal switch in the following procedures:
- remove the air cleaner box. Refer to “air cleaner box removal and installation” in section 1d .
- Disconnect the left handlebar switch coupler (1).
(Yellow)
- Inspect the turn signal switch for continuity with the
tester. If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “handlebar removal and installation” in section 6b .
Special tool
: 09900–25008 (multi circuit tester
set)
Tester knob indication
continuity ( 
)
- After finishing the turn signal switch inspection, reinstall the removed parts.
Hazard switch inspection
Inspect the hazard switch in the following procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the left handleba ...
Dimmer / passing light switch inspection
Inspect the dimmer/passing light switch in the following
procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect th ...
Other materials:
Valve guide replacement
Remove the cylinder head. Refer to “engine top side disassembly” .
Remove the valves. Refer to “cylinder head disassembly and assembly” .
Using the valve guide remover, drive the valve guide
out toward the intake or exhaust camshaft side.
Special tool
(a): 09916–43211 (valve ...
Rear brake hose removal and installation
Removal
Drain brake fluid. Refer to “brake fluid replacement” .
Remove the rear brake hoses as shown in the rear brake hose routing
diagram. Refer to “rear brake hose routing diagram” .
Installation
Caution
the seal washers should be replaced with
new ones to prevent ...
DTC “c60” (p0480): cooling fan relay
circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Cooling fan relay signal is not input to ecm.
Cooling fan relay circuit open or short.
Ecm malfunction.
Wiring diagram
Troubleshooting
Caution
when using ...