Note the malfunction code is memorized in the ecm also when the lead wire coupler of any sensor is disconnected. Therefore, when a lead wire coupler has been disconnected at the time of diagnosis, erase the stored malfunction history code using sds. |
DTC “c28” (p1655): secondary throttle
valve actuator (stva) malfunction
Detected condition and possible cause
Detected condition
Possible cause
The operation voltage does not reach the stva.
Ecm does not receive communication signal from the
stva. Stva can not operate properly or its motor locked
Stva malfunction.
...
Starter motor disassembly and assembly
Refer to “starter motor removal and installation” .
Disassembly
Disassemble the starter motor as shown in the starter motor components
diagram. Refer to “starter motor components” .
Assembly
Reassemble the starter motor in the reverse order of
removal. Pay attention to the following points:
...
Right handlebar
Engine stop switch 1
"" Position
The ignition circuit is off. The
engine cannot start or run.
"" Position
The ignition circuit is on and the
engine can run.
Front brake lever 2
Apply the front brake by squeezing
the front brake lever towards
the grip. The brake ligh ...