Special tool
: 09900–25008
(multi circuit tester set)
Note
|
Special tool
(a):
09900–25009 (needle-point probe set)
Use of sds diagnosis reset procedures
Note
the malfunction code is memorized in the
ecm also when the lead wire coupler of any
sensor is disconnected. Therefore, when a
lead wire coupler has been disconnected at
the time of diagnosis, erase the stored
malfunction history code using sds.
After repairing ...
Fastener removal and installation
Type a
Removal
Depress the head of fastener center piece (1).
Pull out the fastener (2).
Installation
Let the center piece stick out toward the head so that
the pawls “a” closes.
Insert the fastener into the installation hole.
Note
to prevent the pawl ...
DTC “c29” (p1654-h/l): secondary throttle
position sensor (stps) circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
C29
Output voltage is not within the following
range.
Difference between actual throttle opening
and opening calculated by ecm is larger
than specified value.
0.15 V ≤ Sensor ...