The transmission is provided to keep the engine operating smoothly in its normal operating speed range. The gear ratios have been carefully chosen to meet the characteristics of the engine. The rider should always select the most suitable gear for the prevailing conditions. Never slip the clutch to control road speed, but rather downshift to allow the engine to run within its normal operational range. The table below shows the approximate speed range for each gear.
Shifting up schedule
Shifting down schedule
Disengage the clutch when the motorcycle speed drops below 12 miles/h (20 km/h).
Warning
Reduce speed before downshifting. |
Warning
Reduce your speed and downshift before entering the corner. |
Caution Revving the engine into the red zone can cause severe engine damage. Never allow the engine to rev into the red zone in any gear. |
Steering damper maintenance
Keep the steering damper
shaft 1 clean at all times.
Wipe off any oil residue with a
cloth.
Do not confuse the grease-like
residue on the steering damper's
shaft with an oil leak. Collection of
this residue is normal and is from
oil seal lubricant used in the
damper.
Yo ...
Left handlebar
Clutch lever 1
The clutch lever is used for disengaging
the drive to the rear wheel
when starting the engine or shifting
the transmission gear.
Squeezing the lever disengages
the clutch.
Headlight flasher switch 2
Press the switch to light the headlight.
Dimmer switch 3
" " ...
Tampering with noise control system prohibited
Federal law prohibits the following
acts or the causing there of;
The removal or rendering inoperative
by any person other
than for purposes of maintenance,
repair, or replacement,
of any device or element of
·design incorporated into any
new vehicle for the purpose of
noise ...