Suzuki GSX-R 1000 Service Manual: Water hose inspection
Inspect the water hoses in the following procedures:
- remove the side cowlings. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).
- Check the water hoses for crack, damage or engine coolant leakage. If any defect is found, replace the water hose with a new one.
- Any leakage from the connecting section should be corrected by proper tightening. Refer to “water hose routing diagram” .
- After finishing the water hoses inspection, reinstall the removed parts.
Radiator / cooling fan motor removal and
installation
Removal
Remove the inner under cowlings. Refer to “exterior parts removal and
installation” in section 9d .
Drain engine coolant. Refer to “cooling system inspection” in section
0b . ...
Water hose removal and installation
Removal
Remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Drain engine coolant. Refer to “cooling system inspection” in section
...
Other materials:
Fuel injector inspection and cleaning
Inspect the fuel injector in the following procedures:
remove the fuel injector. Refer to “throttle body disassembly and
assembly” in section 1d .
Check the fuel injector for evidence of dirt and
contamination. If present, clean and check for
presence of dirt in the fuel lin ...
Iap sensor removal and installation
Removal
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the coupler (1) and vacuum hose (2).
Remove the iap sensor (3) from the air cleaner box.
Installation
Install the iap sensor in the reverse ord ...
DTC “c60” (p0480): cooling fan relay
circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Cooling fan relay signal is not input to ecm.
Cooling fan relay circuit open or short.
Ecm malfunction.
Wiring diagram
Troubleshooting
Caution
when using ...