Suzuki GSX-R 1000 Service Manual: Water hose removal and installation
Removal
- Remove the side cowlings. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).
- Drain engine coolant. Refer to “cooling system inspection” in section 0b .
- Lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).
- Remove the water hose as shown in the water hose routing diagram. Refer to “water hose routing diagram” .
Installation
- Install the water hose as shown in the water hose routing diagram. Refer to “water hose routing diagram” .
- Install the fuel tank. Refer to “fuel tank removal and installation” in section 1g .
- Pour engine coolant and bleed air from the cooling circuit. Refer to “cooling system inspection” in section 0b .
- Install the side cowlings. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).
Water hose inspection
Inspect the water hoses in the following procedures:
remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Check the water hose ...
Radiator reservoir tank inspection
Inspect the radiator reservoir tank in the following
procedures:
remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Inspect the rad ...
Other materials:
Front fork components
Front fork cap
O-ring
Rebound damping force adjuster rod
Compression damping force adjuster rod
Piston rod nut
O-ring
Piston ring
Rod guide case
Spring
Piston rod
Spring collar b
Spring
Spring collar a
Slide bushing
Outer tu ...
Clutch removal
Drain engine oil. Refer to “engine oil and filter replacement” in
section 0b .
Lift and support the fuel tank with the prop stay.
Refer to “fuel tank removal and installation” in section 1g .
Disconnect the ckp sensor coupler (1).
Remove the clutch cover (2).
...
Specifications
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Chassis bolt and nut inspection”
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...