Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Water pump construction

Suzuki GSX-R. Water pump construction



  1. Impeller
  2. Mechanical seal
  3. Oil seal
  4. O-ring
  5. O-ring
  6. 8
    N·m (0.8 Kgf-m, 6.0 Lbf-ft)
  7. 10 N·m
    (1.0 Kgf-m, 7.0 Lbf-ft)

Apply grease.


Apply engine coolant.


Apply molybdenum oil
solution.

Do not reuse.

Water pump components
Impeller Mechanical seal Oil seal O-ring O-ring 8 N·m (0.8 Kgf-n, 6.0 Ib-ft) 10 N·m (1.0 Kgf-n, 7.0 Ib-ft) 6 N·m (0.6 Kgf-n, 4.5 Ib-ft) ...

Water pump removal and installation
Removal Note before draining engine oil and engine coolant, inspect engine oil and coolant leakage between the water pump and crankcase. If engine oil is leaking, visually inspect t ...

Other materials:

Rear brake components
Rear brake caliper Piston seal Dust seal Piston Rear caliper bracket Rear brake pad set Rear brake disc Brake pad spring 6 N·m (0.6 Kgf-m, 4.5 Lbf-ft) 27 N·m (2.7 Kgf-m, 19.5 Lbf-ft) 12 N·m (1.2 Kgf-m, 8.5 Lbf-ft) 17 N·m ...

Oil pressure indicator inspection
Inspect the oil pressure indicator in the following procedures: Note before inspecting the oil pressure switch, check if the engine oil level is correct. Refer to “engine oil and filter replacement” in section 0b . Remove the left side cowling. Refer to “exterior parts remov ...

Engine sprocket removal and installation
Removal Remove the gearshift link arm (1) from the gearshift shaft. Note mark the gearshift shaft head at which the gearshift link arm slit set for correct reinstallation. Remove the speed sensor (2). Remove the engine sprocket cover (3). Support the ...

© 2011-2024 Copyright www.suzukigsxr.org