Refer to “water pump removal and installation” .
Disassembly
Note if there is no abnormal condition, the mechanical seal removal is not necessary. |
Special tool
(a): 09921–20240 (bearing remover
set)
Note if there is no abnormal condition, the oil seal removal is not necessary. |
Assembly
Caution the removed oil seal must be replaced with a new one. |
Note the stamped mark on the oil seal should face mechanical seal side. |
Special tool
(a): 09913–70210 (bearing
installing set (10
– 75 ö))
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
Caution the removed mechanical seal must be replaced with a new one. |
Note on new mechanical seals, the sealer “a” has been applied. |
M/o: molybdenum oil (molybdenum oil solution)
Note the paint marked side “b” of mechanical seal ring faces the rubber seal. |
Note the metal side “c” of seal washer and the curved side “d” of washer face the impeller securing bolt head. |
Tightening torque impeller securing bolt (a): 8 n·m (0.8 Kgf-m, 6.0 Lbf-ft)
Caution use a new o-ring to prevent engine coolant leakage. |
Tightening torque water pump case screw: 6 n·m (0.6 Kgf-m, 4.5 Lbf-ft)
Caution use a new gasket washer to prevent engine coolant leakage. |
Tightening torque water pump air bleeder bolt (b): 13 n·m (1.3 Kgfm, 9.5 Lbf-ft)
Use of sds diagnosis reset procedures
Note
the malfunction code is memorized in the
ecm also when the lead wire coupler of any
sensor is disconnected. Therefore, when a
lead wire coupler has been disconnected at
the time of diagnosis, erase the stored
malfunction history code using sds.
After repairing ...
Specifications
Service data
Wattage
unit: w
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Rear lighting system construction” “license plate light
components” “reflex reflector construction”
Reference: for the ...
Fuel and oil recommendation
Fuel (for USA and Canada)
Use only unleaded gasoline of at least 90 pump octane
(r/2 + m/2).
Gasoline containing mtbe (meltyl tertiary butyl ether),
less than 10% ethanol, or less than 5% methanol with
appropriate cosolvents and corrosion inhibitor is
permissible.
Fuel (for other countries) ...