Removal
Note before draining engine oil and engine coolant, inspect engine oil and coolant leakage between the water pump and crankcase. If engine oil is leaking, visually inspect the oil seal and o-ring. If engine coolant is leaking, visually inspect the mechanical seal and seal washer. Refer to “water pump related parts inspection” . |
Installation
Install the water pump in the reverse order of removal.
Pay attention to the following points:
Caution replace the o-ring with the a new one. |
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
Tightening torque water pump mounting bolt (a): 10 n·m (1.0 Kgfm, 7.0 Lbf-ft)
Specifications
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Rear view mirror construction”
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torque list” in section 0c . ...
Rear wheel related parts inspection
Refer to “rear wheel assembly removal and installation” .
Tire
Refer to “tire inspection” in section 0b .
Rear brake disc
Refer to “rear brake disc inspection” in section 4c .
Wheel damper
Refer to “drive chain related parts inspection” in section 3a .
Sprocket
Refer to “drive chain ...
Ignition coil inspection
Refer to “electrical components location” in section 0a .
Ignition coil primary peak voltage
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect all ignition coil. Refer to “ignition coil and spark plug
removal and installation” .
...