Suzuki GSX-R 1000 Service Manual: Wheel balance check and adjustment
Check and adjust the wheel balance in the following procedures:
- removal the wheel assembly. Refer to “front wheel assembly removal and installation” and “rear wheel assembly removal and installation” .
- Remove the mounting drum from the rear wheel.
(For rear wheel) refer to “rear wheel assembly removal and installation” .
- Check the wheel balance using the balancer and adjust the wheel balance if necessary.
| Caution for operating procedures, refer to the instructions supplied by the wheel balancer manufacturer. |
- When installing the balancer weight to the wheel, set the balancer weight on center rib of the wheel.
- Recheck the wheel balance.
- Install the mounting drum to the rear wheel. (For rear wheel) refer to “rear wheel assembly removal and installation” .
- Install the wheel assembly. Refer to “front wheel assembly removal and installation” and “rear wheel assembly removal and installation” .
Air valve removal and installation
Removal
Remove the wheel assembly. Refer to “front wheel assembly removal and
installation” and “rear wheel assembly removal and installation” .
Remove the tire. Refer to “tire re ...
Specifications
Service data
Wheel
unit: mm (in)
Tire
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Front wheel components” ...
Other materials:
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Water hose routing diagram” “water pump components” “water
pump construction”
Special tool
...
DTC “c40” (p0505 / p0506 / p0507): isc
valve circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
C40/P0505
The circuit voltage of motor drive is
unusual.
Isc valve circuit open or shorted to ground.
Air passage clogged.
Isc valve is fixed.
Isc valve prese ...
Excva pulley inspection
Inspect the excva pulley in the following procedures:
remove the excva pulley. Refer to “excv cable removal and installation”
.
Visually inspect the excva pulley for wear and
damage. If there is anything unusual, replace the
pulley with a new one.
Install the pulle ...