Refer to “tire removal and installation” .
Wheel
Wipe the wheel clean and check for the following points:
Tire
Tire must be checked for the following points:
Air valve
Inspect the air valve for peeling and damage. If any defect is found, replace the air valve with a new one.
Refer to “air valve removal and installation” (page 2d- 16).
Inspect the valve core seal (1) for wear and damage. If any defect is found, replace the valve core with a new one. Refer to “air valve removal and installation” .
|
Front wheel removal
Place the motorcycle on the
side stand.
Remove both brake calipers
from the front forks by removing
two mounting bolts 1 on
each calipers.
Note: never squeeze the front
brake lever with the caliper
removed. It is very difficult to force
the pads back into the caliper
asse ...
Left handlebar
Clutch lever 1
The clutch lever is used for disengaging
the drive to the rear wheel
when starting the engine or shifting
the transmission gear.
Squeezing the lever disengages
the clutch.
Headlight flasher switch 2
Press the switch to light the headlight.
Dimmer switch 3
" " ...
Rear brake components
Rear brake caliper
Piston seal
Dust seal
Piston
Rear caliper bracket
Rear brake pad set
Rear brake disc
Brake pad spring
6
N·m (0.6 Kgf-m, 4.5 Lbf-ft)
27 N·m
(2.7 Kgf-m, 19.5 Lbf-ft)
12 N·m
(1.2 Kgf-m, 8.5 Lbf-ft)
17 N·m ...