Suzuki GSX-R 1000 Owners Manual: Inspection after cleaning
For extended life of your motorcycle, lubricate according to "general lubrication" section .
 Warning
Avoid a possible accident by expecting longer stopping distances after washing your motorcycle. Apply brakes several times to let heat dry the brake pads or shoes. |
Follow the procedures in the "inspection before riding" section to check your motorcycle for any problems that may have arisen during your last ride.
Windshield cleaning
Clean the windshield with soft
cloth and warm water with mild
detergent. If scratched, polish
with a commercially available
plastic polish. Replace the windshield
if it becomes scratched or
disc ...
Other materials:
Engine stop switch inspection
Inspect the engine stop switch in the following
procedures:
turn the ignition switch off.
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the right handlebar switch coupler (1).
Inspect the engine stop ...
Transmission installation
Install the transmission in the reverse order of removal.
Pay attention to the following points:
Bearing and oil seal
Caution
replace the removed bearings and oil seals
with new ones.
Install the driveshaft left bearing oil seal into the
retainer using the special tool.
...
Spring pre-load adjustment
To change the spring pre-load,
turn the adjuster 1 clockwise or
counterclockwise. Turning the
adjuster clockwise will increase
the spring pre-load. Turning the
adjuster counterclockwise will
decrease the spring pre-load.
There are five grooved lines on
the side of the adjuster 1 for re ...