Suzuki GSX-R 1000 Service Manual: Specifications
Service data
Clutch unit: mm (in)
Tightening torque specifications
| Note the specified tightening torque is described in the following. “Clutch control system components” “clutch components” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Clutch lifter pin inspection and adjustment
Refer to “clutch removal” and “clutch installation” .
Note
when inspection and adjusting the clutch
lifter pin, it is not necessary to install the
clutch onto the countershaft.
...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Clutch control system components” “clutch components”
Special tool
...
Other materials:
DTC “c15” (p0115-h/l): ect sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C15
Output voltage is not with in the following
range.
0.15 V ≤ Sensor voltage < 4.85 V
Ect sensor circuit open or short.
Ect sensor malfunction.
Ec ...
Swingarm removal and installation
Removal
Cut the drive chain. Refer to “drive chain replacement” in section 3a .
Remove the rear wheel assembly. Refer to “rear wheel assembly removal
and installation” in section 2d .
Disconnect the rear brake hose from the brake hose
clamp (1).
Remove the brake ho ...
Regulator / rectifier inspection
Inspect the regulator/rectifier in the following procedures:
turn the ignition switch off.
Disconnect the regulator/rectifier couplers. Refer to “regulator /
rectifier removal and installation” .
Measure the voltage between the terminals using the multi-circuit
tester ...