
Inspect the fuel hoses for damage and fuel leakage. If any defects are found, the fuel hoses must be replaced.
Throtile cable play
Clutch adjustmentDrive chain replacement
Use the special tool in the following procedures, to cut
and rejoin the drive chain.
Note
when using the special tool, apply a small
quantity of grease to the threaded parts of
the special tool.
Special tool
: 09922–22711 (drive chain cutting
and joint
tool set)
Driv ...
Throttle valve synchronization
Check and adjust the throttle valve synchronization
among four cylinders.
Start the engine and run it in idling condition
for
warming up.
Stop the warmed-up engine.
Lift and support the fuel tank. Refer to “fuel
tank
removal and installation” in section 1g (page ...
Damping force adjustment
The rebound and compression
damping force can be individually
adjusted by turning the respective
adjusters. The rebound damping
force adjuster 1 is located at the
bottom of the rear suspension.
The compression damping force
adjuster 2 is located at the left
side of the motorcycle.
To ad ...