The wattage rating of each bulb is shown in the following chart.
When replacing a burned-out bulb, always use the same wattage rating according to the following chart.
|
Caution Using a light bulb with the wrong wattage rating can cause electrical system damage or shorten bulb life. Always use the specified light bulb. |

Rear wheel removal
HeadlightSelf-diagnosis function
The self-diagnosis function is incorporated in the ecm. The function has two
modes, “user mode” and “dealer mode”.
The user can only be notified by the lcd (display) panel and led (fi indicator
light). To check the function of the
individual fi system devices, the dealer mode is provided. In ...
Regulator / rectifier inspection
Inspect the regulator/rectifier in the following procedures:
turn the ignition switch off.
Disconnect the regulator/rectifier couplers. Refer to “regulator /
rectifier removal and installation” .
Measure the voltage between the terminals using the multi-circuit
tester ...
Clutch control system components
Push rod
Clutch release camshaft
Clutch release arm
Clutch cable
1 N·m (0.1 Kgf-m, 0.7
Lbf-ft)
6 N·m
(0.6 Kgf-m, 4.5 Lbf-ft)
10 N·m
(1.0 Kgf-m, 0.7 Lbf-ft)
Apply grease
Do not reuse.
...