Suzuki GSX-R 1000 Service Manual: Ckp sensor removal and installation
Removal
- Remove the clutch cover. Refer to “clutch removal” in section 5c .
- Remove the ckp sensor (1).
Installation
Install the ckp sensor in the reverse order of removal.
Refer to “clutch installation” in section 5c .
Iap sensor inspection
Refer to “dtc “c13” (p0105-h/l): iap sensor circuit malfunction” in section 1a .
Cmp sensor removal and installation
Removal
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Remove the pair control solenoid valve. Refer to “pair control solenoid
valve ...
Iap sensor removal and installation
Removal
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the coupler (1) and vacuum hose (2).
Remove the iap ...
Other materials:
Throttle cable play inspection and adjustment
Inspect throttle cable play
initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter
Inspect and adjust the throttle cable play “a” as follows:
Throttle cable play “a”
2.0 – 4.0 Mm (0.08 – 0.16 In)
Remove the boot (1).
Loosen the lock-nu ...
Valve guide replacement
Remove the cylinder head. Refer to “engine top side disassembly” .
Remove the valves. Refer to “cylinder head disassembly and assembly” .
Using the valve guide remover, drive the valve guide
out toward the intake or exhaust camshaft side.
Special tool
(a): 09916–43211 (valve ...
Excva removal and installation
Removal
Turn the ignition switch off.
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Connect the special tool (mode select switch) to the dealer mode
coupler. Refer to “self-diagnostic procedures” in section 1a .
After tur ...