Warning
Follow loading limits and loading guidelines in this manual. |
(Gross vehicle weight) of this motorcycle. The g.V.W. Is the combined weight of the machine, accessories, payload and riders. When selecting your accessories, keep in mind the weight of the rider as well as the weight of the accessories.
The additional weight of the accessories may not only create an unsafe riding condition but may also affect the riding stability
G.V.W.: 375 Kg (830 lbs) at the tire pressure (cold) front: 2.50 Kgf/cm2 (36 psi) rear: 2.90 Kgf/cm2 (42 psi)
Accessory installation
guideline
Loading guidelinesConrod crank pin bearing inspection and
selection
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Inspection
Inspect the bearing surfaces for any signs of fusion,
pitting, burn or flaws. If any, replace them with a
specified set of bearings.
Place the plastigauge axially along ...
DTC “c11” (p0340): cmp sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
The signal does not reach ecm for 3 sec. Or more, after
receiving the starter signal.
Cmp sensor circuit open or short.
Cmp sensor malfunction.
Ecm malfunction.
...
Clutch removal
Drain engine oil. Refer to “engine oil and filter replacement” in
section 0b .
Lift and support the fuel tank with the prop stay.
Refer to “fuel tank removal and installation” in section 1g .
Disconnect the ckp sensor coupler (1).
Remove the clutch cover (2).
...