Suzuki GSX-R 1000 Owners Manual: Motorcycle cleaning
Corrosion prevention
It is important to take good care of
your motorcycle to protect it from
corrosion and keep it looking new
for years to come.
Important information about
corrosion
Common causes of corrosion
...
Washing the motorcycle
When washing the motorcycle,
follow the instructions below:
Remove dirt and mud from the
motorcycle with running water.
You may use a soft sponge or
brush. Do not use hard materials
...
Other materials:
Specifications
Service data
Drive train
unit: mm (in) except ratio
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Drive chain related components”
Reference: for the tightening torque of fastener not specified in this
section ...
Conrod crank pin bearing removal and
installation
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Removal
Remove the conrod crank pin bearings (1).
Note
do not remove the bearings (1) unless
absolutely necessary.
Make a note of where the bearings are
removed ...
Front wheel removal
Place the motorcycle on the
side stand.
Remove both brake calipers
from the front forks by removing
two mounting bolts 1 on
each calipers.
Note: never squeeze the front
brake lever with the caliper
removed. It is very difficult to force
the pads back into the caliper
asse ...