Suzuki GSX-R 1000 Service Manual: Rear suspension inspection
Inspect rear suspension every 12 000 km (7 500 miles, 24 months)
Inspect the rear shock absorber for oil leakage and check that there is no play in the swingarm.
Replace any defective parts, if necessary. Refer to “rear shock absorber removal and installation” in section 2c , “cushion lever removal and installation” in section 2c and “swingarm removal and installation” in section 2c .
Front fork inspection
Inspect front fork
every 12 000 km (7 500 miles, 24 months)
Inspect the front forks for oil leakage, scoring or
scratches on the outer surface of the inner tubes.
Replace any defective parts, if ...
Chassis bolt and nut inspection
Tighten chassis bolt and nut
initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter
Check that all chassis bolts and nuts are tightened to
their specifi ...
Other materials:
Drive mode selector description
Engine power characteristics can be changed in 3
modes by operating the drive mode selector to meet
various riding conditions and rider’s preference.
Operation
Drive mode is preset at a-mode when the ignition switch
and engine stop switch are turned on. Follow the
procedure below to operat ...
Engine assembly installation
Install the engine in the reverse order of engine removal.
Pay attention to the following points:
before installing the engine, install the collars (1).
Before installing the engine, install the engine
mounting thrust adjusters (2).
Gradually raise the rear side of ...
Conrod and crankshaft inspection
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Conrod small end I.D.
Measure the conrod small end inside diameter using the
small bore gauge.
If the conrod small end inside diameter exceeds the
service limit, replace the conrod.
Special ...