Recommended service material

Special tool

SpecificationsFront wheel dust seal / bearing removal and installation
Removal
Remove the front wheel assembly. Refer to “front wheel assembly removal
and installation” .
Remove the dust seals using the special tool.
Special tool
(a): 09913–50121 (oil
seal remover)
Remove the wheel bearings using the special tool.
Special tool
(b): 099 ...
Tp sensor removal and installation
Refer to “throttle body disassembly and assembly” in section 1d .
Removal
Remove the throttle body. Refer to “throttle body
removal and installation” in section 1d (page 1d-
10).
Remove the tp sensor (1) with the special tool.
Special tool
: 09930–11950 (torx wrench (5 mm))
...
Ignition system check
Remove the spark plugs and
reattach them to the spark
plug caps.
Put the engine stop switch in
the "" position and ignition
switch in the "on" position.
While holding a spark plug
with its base firmly against the
engine, push the electric
starter butt ...