Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Specifications

Service data

Fi sensors

Suzuki GSX-R. Fi sensors


Tightening torque specifications

Suzuki GSX-R. Tightening torque specifications


Reference

: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .

Isc valve preset and opening initialization
When removing or replacing the isc valve, set the isc valve to the following procedures:  turn the ignition switch on.  Set up the sds tool. (Refer to the sds operation manual for f ...

Special tools and equipment
Special tool ...

Other materials:

Turn signal / side-stand relay inspection
Refer to “electrical components location” in section 0a . Note make sure that the battery is fully charged. Before removing the turn signal/side-stand relay, check the operation of the turn signal light. If the turn signal light does not illuminate, inspect the bulb, turn signa ...

Ecm / various sensors
Since each component is a high-precision part, great care should be taken not to apply any severe impacts during removal and installation. Be careful not to touch the electrical terminals of the electronic parts (ecm, etc.). The static electricity from your body may damage them. ...

Gear position (gp) switch removal and installation
Removal Turn the ignition switch off.  Lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).  Disconnect the gear position switch lead wire coupler (1). Remove the engine sprocket cover. Refer to “engine sprocket r ...

© 2011-2026 Copyright www.suzukigsxr.org