Service data
Brake unit: mm (in)

Tightening torque specifications

| Note the specified tightening torque is described in the following. “Rear brake components” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Rear brake disc inspection
Special tools and equipmentConrod crank pin bearing inspection and
selection
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Inspection
Inspect the bearing surfaces for any signs of fusion,
pitting, burn or flaws. If any, replace them with a
specified set of bearings.
Place the plastigauge axially along ...
Transmission components
2Nd drive gear
6Th drive gear
3Rd/4th drive gear
5Th drive gear
Countershaft/1st drive gear
Driveshaft
2Nd driven gear
6Th driven gear
3Rd driven gear
4Th driven gear
5Th driven gear
1St driven gear
Gearshift cam stopper
Gearshi ...
Tp reset
When replacing the throttle body assembly or tp sensor
with a new one or reinstalling the tp sensor, reset the
tp learned value in the following procedures:
Note
keep the throttle valves fully closed while
resetting the tp learned value.
Turn the ignition switch on.
...