Service data
Wattage unit: w

Tightening torque specifications

| Note the specified tightening torque is described in the following. “Rear lighting system construction” “license plate light components” “reflex reflector construction” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Dimmer / passing light switch inspection
Special tools and equipmentEngine oil and filter change
Change the engine oil and oil filter
at the scheduled times. The
engine should always be warm
when the oil is changed so the oil
will drain easily. The procedure is
as follows:
Place the motorcycle on the
side stand.
Remove the three screws of
the right fairing 1.
...
Engine coolant
Coolant level
The engine coolant solution
should be between "f" (full) and
"1..:' (Low) level lines on the engine
coolant reservoir. If the level is
lower than "1..:' (Low) level line,
bring it up to "f" (full) level by adding
50:50 mixture of distilled water ...
Cam chain guide / cam chain tensioner
removal and installation
Removal
Remove the cylinder head cover. Refer to “engine top side disassembly” .
Remove the cam chain guide no. 2 (1).
Remove the cylinder head. Refer to “engine top side disassembly”
and “engine bottom side disassembly” .
Remove the starter clutch. Refer to “s ...