Recommended service material

| Note required service material is also described in the following. “Rear lighting system construction” |
Special tool

SpecificationsRear shock absorber removal and installation
Removal
Remove the right side cowling and side frame covers. Refer to “exterior
parts removal and installation” in section 9d .
Support the motorcycle with a jack to relieve load on
the rear shock absorber.
Remove the left muffler and muffler chamber heat guard no. 2. Refer ...
Rear brake light switch inspection
Inspect the rear brake light switch in the following
procedures:
lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Disconnect the rear brake light switch lead wire
coupler (1).
Inspect the rear brake light swi ...
Steering / steering damper removal and
installation
Removal
steering damper
Turn the ignition switch off.
Disconnect the steering damper solenoid coupler
(1).
Remove the lower bracket cover (2).
Remove the steering damper mounting nut (3) while
holding the lock-nut (4).
Remove the steering damper mounting bolt ( ...