Suzuki GSX-R 1000 Service Manual: Wheel / tire / air valve inspection and cleaning
Refer to “tire removal and installation” .
Wheel
Wipe the wheel clean and check for the following points:
- distortion and crack
- any flaws and scratches at the bead seating area.
- Wheel rim runout. Refer to “front wheel related parts inspection” and “rear wheel related parts inspection” .
Tire
Tire must be checked for the following points:
- nick and rupture on side wall
- tire tread depth (refer to “tire inspection” in section 0b .)
- Tread separation
- abnormal, uneven wear on tread
- surface damage on bead
- localized tread wear due to skidding (flat spot)
- abnormal condition of inner liner
Air valve
Inspect the air valve for peeling and damage. If any defect is found, replace the air valve with a new one.
Refer to “air valve removal and installation” (page 2d- 16).
Inspect the valve core seal (1) for wear and damage. If any defect is found, replace the valve core with a new one. Refer to “air valve removal and installation” .
|
Tire removal and installation
Removal
The most critical factor of a tubeless tire is the seal
between the wheel rim and the tire bead. For this
reason, it is recommended to use a tire changer that can
satisfy this sealing requ ...
Air valve removal and installation
Removal
Remove the wheel assembly. Refer to “front wheel assembly removal and
installation” and “rear wheel assembly removal and installation” .
Remove the tire. Refer to “tire re ...
Other materials:
Turn signal / side-stand relay inspection
Refer to “electrical components location” in section 0a .
Note
make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signa ...
Oil pressure regulator / oil strainer
inspection
Refer to “oil pan / oil pressure regulator / oil strainer removal and
installation” .
Oil pressure regulator
Inspect the operation of the oil pressure regulator by
pushing the piston with a proper bar.
If the piston does not operate smoothly, replace the oil
pressure regulator with a new on ...
DTC “c49” (p1656): pair control solenoid
valve circuit malfunction
Detected condition and possible cause
Detected condition
Possible cause
Pair control solenoid valve voltage is not input to ecm
Pair control solenoid valve circuit open or short.
Pair control solenoid valve malfunction.
Ecm malfunction.
...