Stp sensor adjustment
Adjust the stp sensor in the following procedures:
remove the air cleaner box cover. Refer to “air cleaner element removal
and installation” in section 1d .
Disconnect the stva lead wire coupler (1).
Insert the needle pointed probes to the stp sensor
coupler (between y/w a ...
Component location
Electrical components location
Ignition switch/immobilizer antenna
Iat sensor
Secondary fuel injector
Primary fuel injector
Iap sensor
Evap system purge control solenoid valve
Fuel pump relay
Turn signal/side-stand relay
Cooling fan relay
Ect ...
Clutch parts inspection
Refer to “clutch removal” and “clutch installation” .
Clutch drive and driven plate
Note
wipe off the engine oil from the drive and
driven plates with a clean rag.
Measure the thickness of drive plates with a vernier
calipers. If the drive plate thickness is found to have ...