Front brake hose removal and installation
Removal
Drain brake fluid. Refer to “brake fluid replacement” .
2) Remove the front brake hoses as shown in the front brake hose routing
diagram. Refer to “front brake hose routing diagram” .
Installation
Caution
the seal washers should be replaced with the
new ones to pr ...
Continuity check
Measure resistance across coupler “b” (between “a”
and “c” in figure).
If no continuity is indicated (infinity or over limit), the
circuit is open between terminals “a” and “c”.
Disconnect the coupler “b” and measure resistance
between couplers “a” and “b-1”.
If no continuity ...
Balancer shaft disassembly and assembly
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Disassembly
Remove the balancer shaft. Refer to “engine bottom side disassembly” .
Remove the washers, balancer gear and dampers
from the shaft.
Assembly
Assembly is in the re ...