Damping force adjustment
Break-inOil cooler / oil cooler hose inspection and
cleaning
Refer to “exterior parts removal and installation” in section 9d .
Oil cooler hose inspection
Inspect the oil cooler hoses for any damage and oil
leakage. If any defects are found, replace the oil cooler
hose with a new one.
Oil cooler inspection
Remove the oil cooler guard (1).
...
Exhaust control system construction
Excv cable no. 1 (Cl)
Excv cable no. 2 (Op)
When
loosening or tightening the pulley bolt, be sure to fix the
pulley with an adjustable wrench, or excva may get damaged.
5 N·m (0.5 Kgf-m, 3.5 Lbf-ft)
42 – 43 Mm (1.65 – 1.69 In)
60 – 61 Mm (2.36 – ...
Turn signal / side-stand relay inspection
Refer to “electrical components location” in section 0a .
Note
make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signa ...