Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Horn removal and installation

Removal

  1. Disconnect the horn coupler (1).
  2.  Remove the horn (2) by removing the mounting bolts.

Suzuki GSX-R. Horn removal and installation


Installation

Install the horn in the reverse order of removal.

Horn inspection
Note if the horn sound condition is normal, it is not necessary to inspect the horn button continuity. Horn button inspection Remove the air cleaner box. Refer to “air cleane ...

Specifications
Service data Wattage unit: w Tightening torque specifications Reference: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section ...

Other materials:

Rear lighting system construction
License plate light assembly Reflex reflector (e-03, 28, 33 only) Clamp : clamp the license plate light lead wire so as not to be slack. Rear combination light Rear turn signal light assembly (lh/rh) 5 N·m (0.5 Kgf-m, 3.5 Lbf-ft) 1.8 N·m ...

Rear brake light switch inspection
Inspect the rear brake light switch in the following procedures:  lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).  Disconnect the rear brake light switch lead wire coupler (1). Inspect the rear brake light swi ...

Rear shock absorber adjustment
After installing the rear suspension, adjust the spring pre-load and damping force as follows: Spring pre-load adjustment The set length 179.3 Mm (7.06 In) provides the maximum spring pre-load. The set length 189.3 Mm (7.45 In) provides the minimum spring pre-load. Std position 184.3 ...

© 2011-2026 Copyright www.suzukigsxr.org