
No spark or poor sparkStarter relay inspection
Inspect the starter relay in the following procedures:
remove the starter relay. Refer to “starter relay removal and
installation” .
Apply 12 v to “a” and “b” terminals and check for
continuity between the positive and negative
terminals using the multi-circuit tester. If th ...
Cushion rod inspection
Refer to “cushion rod removal and installation” .
Collar and spacer
Remove the collar and spacer from the cushion rod.
Inspect the collar and spacer for any flaws or other
damage. If any defects are found, replace it with a
new one.
Cushion rod bearing
Insert the collar a ...
Break-in procedures
During manufacture only the best possible materials are
used and all machined parts are finished to a very high
standard but it is still necessary to allow the moving parts
to “break-in” before subjecting the engine to maximum
stresses. The future performance and reliability of the
engine depen ...