| Caution when you touch the bulb with your bare hands, clean the bulb with a cloth moistened with alcohol or soap water to prevent premature bulb failure. |


Rear turn signal light removal and installation
Reflex reflector constructionRegulated voltage inspection
Inspect the regulated voltage in the following
procedures:
remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Start the engine and keep it running at 5 000 r/min
with the dimmer switch turned hi position.
Measure the dc vo ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Transmission components” “gearshift lever construction”
“gearshift shaft / gearshift cam plate components” “gearshift
shaft construction”
Special to ...
Side-stand / ignition interlock system parts
inspection
Check the interlock system for proper operation. If the
interlock system does not operate properly, check each
component for damage or abnormalities. If any
abnormality is found, replace the component with a new
one.
Side-stand switch
Turn the ignition switch off.
Remove the left si ...