Recommended service material

| Note required service material is also described in the following. “Rear brake components” |
Special tool

SpecificationsRear brake pedal adjustment
The rear brake pedal position
must be properly adjusted at all
times or the disk brake pads will
bear against the disk causing
damage to the pads and to the
disk surface. Adjust the brake
pedal posit~ on in the following
manner:
Loosen lock nut 1, and turn
the push rod 2 to locate t ...
Ecm / various sensors
Since each component is a high-precision part, great
care should be taken not to apply any severe impacts
during removal and installation.
Be careful not to touch the electrical terminals of the
electronic parts (ecm, etc.). The static electricity from
your body may damage them. ...
Thermostat removal and installation
Removal
Drain a small amount of engine coolant. Refer to “cooling system
inspection” in section 0b .
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Remove the thermostat cover (1).
Remove the thermostat ( ...