Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Specifications

Tightening torque specifications

Note

the specified tightening torque is described in the following.

“Body frame construction”  “front footrest bracket construction”  “side-stand construction”

Reference

: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .

Special tools and equipment

Recommended service material

Note

required service material is also described in the following.

“Front footrest bracket construction”  “side-stand construction”  “pillion footrest construction”

Side-stand removal and installation
Removal Support the motorcycle with a jack or wooden block. Caution  do not support the motorcycle with the exhaust pipes.  Make sure that the motorcycle is supported s ...

Other materials:

Side-stand construction
Frame Side-stand bracket Washer Side-stand 50 N·m (5.0 Kgf-m, 36.0 Lbf-ft) 40 N·m (4.0 Kgf-m, 29.0 Lbf-ft) Apply grease to sliding surface. ...

Schematic and routing diagram
Engine lubrication system chart diagram Engine lubrication circuit diagram ...

Piston and piston ring inspection
Refer to “piston ring removal and installation” . Piston diameter Measure the piston diameter using the micrometer at 15 mm (0.6 In) “a” from the skirt end. If the piston diameter is less than the service limit, replace the piston. Special tool (a): 09900–20203 (micrometer (50 – 75 mm)) Pis ...

© 2011-2026 Copyright www.suzukigsxr.org