Refer to “combination meter removal and installation” .
Disassembly disassemble the combination meter as shown in the combination meter components. Refer to “combination meter components” .
Assembly assemble the combination meter as shown in the combination meter components. Refer to “combination meter components” .
Combination meter removal and installation
Combination meter inspectionPair control solenoid valve removal and
installation
Removal
Lift and support the fuel tank with the prop stay.
Refer to “fuel tank removal and installation” in section 1g .
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Remove the pair control solenoid valve (1) along
with the pair ...
Rear wheel assembly removal and installation
Removal
Loosen the axle nut (1).
Raise the rear wheel off the ground and support the
motorcycle with a jack or wooden block.
Caution
make sure that the motorcycle is supported
securely.
Remove the axle nut (1).
Loosen the left and right lock-nuts (2) an ...
Rear wheel removal
Place the motorcycle on the
side stand.
Remove the cotter pin 1.
Remove the axle nut 2.
Warning
A hot muffler can burn you.
The muffler will be hot enough
to burn you for some time after
stopping the engine.
Wait until the muffler cools to
avoid bur ...