Suzuki GSX-R 1000 Owners Manual: If you don't have a helmet, buy a helmet and wear it every time you ride
Most accidents occur within a few miles of home, and almost half occur at speeds of less than 30 mph. So even if you're just going on a quick errand, be preparedstrap on your helmet before you take off.
Helmets do not reduce essential vision or hearing. Generally, helmets do not cause or intensify injury if you crash. Helmets simply help your skull protect your intelligence, your memory, your personality, and your life.
Your eyesight is equally valuable.
Wearing suitable eye protection can help keep your v1s1on unblurred by the wind and save your eyes from airborne hazards like bugs, dirt, or pebbles kicked up by tires.
Most accidents can be avoided
The most common type of motorcycle
accident in the u.S. Occurs
when a car traveling towards a
motorcycle turns left in front of the
motorcycle. Is that because other
drivers are out to get motorc ...
If a collision is imminent, do something
Many riders fear locking up their
brakes or haven't learned to
swerve to avoid an accident.
Many inexperienced riders (and
too many seasoned riders) use
only their rear brake in an emergency,
...
Other materials:
Rear brake pad replacement
Remove the plug (1) and brake pad mounting pin (2).
Remove the brake pads (3).
Caution
do not operate the brake pedal while the
pads are removed.
Clean up the caliper, especially around the caliper
piston.
Caution
replace the brake pads as a s ...
Fail-safe function table
Fi system is provided with fail-safe function to allow the engine to start
and the motorcycle to run in a minimum
performance necessary even under malfunction condition.
The engine can start and can run even if the signal in the table is not
received from each sensor. But, the engine
...
Modification
Modification of the motorcycle, or
removal of original equipment
may render the vehicle unsafe or
illegal. Obey all applicable equipment
regulations in your area.
The frame of this motorcycle is
made of an aluminum alloy.
Therefore, never make any modifications
such as drilling or weldin ...